Charnwood W583 10″ x 7″ Planer Thicknesser
FREE Shipping on this Machine
A solid and well finished planer thicknesser for the busy workshop.
Precision Ground Cast Iron Beds
2hp Induction Motor
3 Knife Cutterblock for Superior Finish
10” Planing Capacity
10” x 7” Thicknessing Capacity
Rubber Coated Outfeed Roller
100mm diameter Dust Extraction Outlet
Optional Wheel Base Available
Precision ground cast iron beds and a long tilting fence which can be positioned at any point across the table make this machine a delight to use. The 3 knife cutterblock is powered by a 2hp induction motor and is capable of a cut up to 5mm deep in a single pass.
To gain better visibility and access for thicknessing, both of the planing beds are hinged and swing out of the way, without using any tools. A dust hood / cutter gaurd is then swung into position and the conversion to Thicknesser is complete.
The feed roller drive, which features a rubber outfeed roller, can be disengaged during planing operations to save motor power and general wear on the machine.
Supplied with 3 knives, 100mm dust extraction outlet, 4 adjustable feet, cable and plug.
Our planer thicknesser will run off any standard 13amp supply.
Surfacing width 250mm (10″)
Length of surfacing tables 1085mm
Maximum depth of cut 5mm
Fence tilt 90 – 45 degrees
Table height 856mm
Thicknessing capacity 5-195mm (1/4″-7″)
Length of thicknessing table 600mm
Feed speed 5.5m/min
Maximum depth of cut 2.5mm
Cutterblock speed 4000rpm
Number of knives 3
Motor ( induction) 1500w (2hp)
Dimensions (WxDxH) 1100mm x 780mm x 1050mm
Warranty 1 Year
It is essential to use dust extraction with a planer thicknesser. The extractor removes all the dust and chips which will otherwise build up, causing a blockage and eventually damage to the machine. Using an extractor also increases the life of the knives.